Marks Trains 15 x 11 x 12 mm – 0.7W Nominal – 1W Peak – 8 Ohm, 3D printed speaker with solder pads – Classic High Definition Sugar Lump Speaker
Ideal for fitting in the base of the cab in older can motor hornby and Bachmann Steamers – Wickness recommended method for these chassis types
Mark’s Trains miniature loudspeaker for sound decoders, measures 15 (L) x 11 (W) x 12 (D) mm with 3D printed baffle. These speakers are manufactured from the highest quality driver units, with solder tabs for ease of installation which also prevent shorts against a metal chassis (when compared to spring contacts).
Solder tabs making soldering much easier than spring contacts
Custom made 3D printed enclosure
Highest build quality
2 of these speakers wired in parallel changes the power output to 2W – 4 Ohm, therefore doubling the sound circuit output in standard OO gauge sound conversions
Ideal for many N gauge installations and many OO where space is at a premium
Sugar-cube Speakers General
Sugar-cubes and Micro-cubes will produce good sound levels whether located in an enclosed space or exposed on the floor of a cab. Just make sure to locate the speaker with the driver unit (metal part) facing up if on the floor or down if stuck to an upper roof with black tack and ensure no live chassis parts can come into contact with the speaker terminals as this will cause a short damaging the sound circuits on the decoder. It is in fact possible to wrap the whole speaker with Kapton tape or heat shrink tubing to prevent shorting and there is little or no reduction in sound depth and quality as a result.